Hello all,
Just wanted to share my DynoJet results for folks to reference.
*Results*: 249whp / 236 ft-lbs @ 65 degrees F and 8% humidity. I switched between 3 different UpRev maps via cruise…
I recently picked up a used pair of tomei test pipes and am about to install them has anybody experienced these I can’t find a single post about them…. my whole plan was to get them on and maybe…
By: Xnqc | March 25, 2021
When applying or even releasing pressure from the accelerator I heard like a ticking or clicking noise, if happens when I’m coasting along and even when pulling away from a stand still. Doesn’t make…
By: figi | March 24, 2021
Took my 2006 touring in to Nissan just to see what they would say about my light always being on( bought the car 2 months ago)
they were kind enough to check all 4 sensors, reset the light without…
So I have an automatic 350z and it seems when I use the sport mode and manually shift at 2000-4000k rpm it tends to shift really hard and “pop” into gear in a sense. I was curious if by letting of…
By: Oz33 | March 19, 2021
I recently replaced my rack and pinion wheel bearings and hubs and compression rods, and about six months before that I’ve redid All the lower arms and ball joints so all the suspension is new in the…
Hello.
I installed inner tie rod spacer for better steering angle.
But this thin spacer only, angle is almost maxed out.
Cause inner side of tire now rubbing the Compression rod.
(Not the…
All times are GMT -8. The time now is 07:23 AM.