Flywheel posistion
#1
Registered User
Thread Starter
Join Date: Dec 2016
Location: South Carolina
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Flywheel posistion
I took off my flywheel to have it resurfaced and I did not mark the position. There is a pin in the crank shaft that I think lines up with one particular hole on the engine side of the flywheel. There also seems to be a cast pointer on the disc side of the flywheel that matches that one particular hole. Is this the way to realign after making that mistake?