FS: 350z utec w/map sensor
09-08-2015, 02:47 PM
#1
350z utec w/map sensor
Hello, Im looking to sell my Utec with Map sensor
I purchased it from another member on here last winter. I was going to use the utec but wasn't able to find anyone near me that would tune it for me so I had to go with Osiris.
I am 100% sure its in good working condition because I installed it and used it to drive my car to my tuner 100kms away.
It's currently tuned for a Vortech with 650cc injectors,plenum spacer,test pipes and return fuel system. When I drove my car up there my AFR at idle was good,but under heavy load it would go leaner than I'd like.So if your set up is close to this you'll have a good base to work off of. Or you can upload base maps from TurboXS' website
Included is the Utec,map sensor,usb cable,molex connector and instruction manual(Not pictured)
I'm asking $300 OBO,plus shipping
I purchased it from another member on here last winter. I was going to use the utec but wasn't able to find anyone near me that would tune it for me so I had to go with Osiris.
I am 100% sure its in good working condition because I installed it and used it to drive my car to my tuner 100kms away.
It's currently tuned for a Vortech with 650cc injectors,plenum spacer,test pipes and return fuel system. When I drove my car up there my AFR at idle was good,but under heavy load it would go leaner than I'd like.So if your set up is close to this you'll have a good base to work off of. Or you can upload base maps from TurboXS' website
Included is the Utec,map sensor,usb cable,molex connector and instruction manual(Not pictured)
I'm asking $300 OBO,plus shipping
Last edited by NissanZcrazy; 09-15-2015 at 05:22 PM. Reason: Price adjustment
Thread
Thread Starter
Forum
Replies
Last Post
etkms
Engine & Drivetrain
29
06-19-2022 06:30 PM
350Z Project X
Maintenance & Repair
11
10-17-2015 05:16 PM