What have you done for your Z today?
Registered User
Join Date: Aug 2016
Location: Pueblo West, Colorado
Posts: 439
Likes: 0
Received 31 Likes
on
27 Posts
I hope so. I also went with motull fluid flush. They'll be seeing track action on the 26th!!!
But probably only a couple times a year.
Unless I come into some big money and buy myself a 370Z nismo and turn this one into a full-blown race car. Lmao.
Hopes and dreams.....
But probably only a couple times a year.
Unless I come into some big money and buy myself a 370Z nismo and turn this one into a full-blown race car. Lmao.
Hopes and dreams.....
New Member
I just bought all the stuff I need to take my driver's side headlamp assembly apart, clean, dry and seal it and put it back together again. I can't wait to get that black rubber butyl crap all over my hands. I'm getting sick of the condensation that showed up inside the housing last month.
New Member
350Z/370Z Tech Moderator
MY350Z.COM
MY350Z.COM
6 inch cawk is my fave!
iTrader: (3)
Not really anything for my z buy I took this apart for the fun of it.
Wish the outside was as nice as the inside, I might have actually wanted to use it..
And here is my other back-up diff
Wish the outside was as nice as the inside, I might have actually wanted to use it..
And here is my other back-up diff
General & Tech Moderator
MY350Z.COM
MY350Z.COM
After consulting some enthusiasts and track guys I went with Bilstein B8s. Next project is the Hotchkis 32/20 setup with Whiteline ends. Almost ready for ZdayZ 2017
The following 3 users liked this post by jhc:
6 inch cawk is my fave!
iTrader: (3)
Master
iTrader: (8)
6 inch cawk is my fave!
iTrader: (3)
took off my utr g3 spoiler. anyone know how to get off the adhesive that was used? it looks like a liquid rubber of some sort. i used a heat gun to take off the spoiler itself but not sure how to get the globs off. not sure why the body shop installed it with this
the adhesive itself is strong and pliable at the same time. tried goo gone and goof off. neither did anything
the adhesive itself is strong and pliable at the same time. tried goo gone and goof off. neither did anything
Registered User
iTrader: (15)
someone else suggested the pinstripe wheel removal tool as well. i just purchased both the 3m adhesive remover and the wheel. will give it a shot. thanks for the recommendations. just surprised goof off didnt get it off either
New Member
Today I curbed rashed my wheel in the narrowest drive-thru (new area) while turning. I have never been pissed before.
Half of the diameter of an 18" wheel is rashed. That is what I did today. Please if anyone knows a really good repair shop, please please cue me in.
Half of the diameter of an 18" wheel is rashed. That is what I did today. Please if anyone knows a really good repair shop, please please cue me in.