MZ front lip by Carbon Creations installed & a bumper tuck using 3M double sided tape & 2x4 wrapped in a towel so I wouldn't scratch the bumper & small jack to hold this stuff in place for a bit. No drilling for this tuck just clean the area before using 3M. One long strip of 3M tape is all that's needed.

 

Different question, but how did that front emblem work out for you? I ordered a set, and it seems too big for my KBD Nismo V2 bumper.

 

I'm interested to see how the 3M holds up with the tuck.

 

It's not a bad idea as long as you really clean the bumper and the rear beam and use 3M's wide double-sided tape. It would look cleaner than having any hardware holding it up, but my concern would be whenever you remove the rear bumper.

 

Pics of underside where the tape was used for mounting.

 

yea - I used a few bolts...I can't see double sided tape holding long term...

 

Fits fine on the V2 luv this emblem.

 

Nice! Is that a KBD or poly V2 as well?