I put the front end of my car back together and have this connector leftover and Im not too sure where it goes. any help is appreciated.

 

I believe thats for the ambient temperature sensor

 

I think bre240 is correct. Also, the shielding looks compromised on the red and black plug wires in your pic. If you use that connector, I would add some shrink tubing over them.
Cheers!
-Icer

 

You are right Icer you can kinda see exposed copper

 

I think its for the A/C refrigerant pressure sensor since the ambient temp switch looks to be plugged in at the bottom of the picture. I think the ambient temp sensor is only two wire as well. But I'm with icer5160 you should probably shrink wrap or at the very least put some electrical tape on the ends of those wires.

 

You're correct. It's for the A/C. He can't find where it goes because it's routed incorrectly. Goes the other direction.

 

Thanks guys ill check it out later I had zip tied it when i took it apart so I was confused since it went the other way