Notices
2003-2009 Nissan 350Z

350Z 2004 Misfire issues ?

Old Jul 30, 2024 | 08:13 AM
  #1  
AlligatorVS's Avatar
AlligatorVS
Thread Starter
New Member
 
Joined: Jun 2024
Posts: 4
Likes: 1
From: SERBIA
Default 350Z 2004 Misfire issues ?

Hello everyone !

Got next issues/codes for my Nissan 350Z 2004 VQ35DE:
  • P0302 (DTC)
  • P0300 (DTC)
  • P0328 (Freeze frame)
  • P000007 (Freeze frame)


I have this car since end of 2023, got it with 66K miles, before issue started to occur, I was riding the car for like 1.500 miles, no issues at all.

Last 4 months, from April to July, car was not driven outside of the garden, just two times to refuel the car in months between from April to July (Total distance was 40-50 miles), and refueled amount was (2.64 liquid gallon), the car itself was working properly, without issues even then.

In meantime, car has been started every 3-5 days in garage, it was working in idle mode for 10-15 mins.

I could hear some strange sound but I wasn't sure about it, so I could easily said there was nothing special, that's the time when the P0328 code appeared in "Freeze frame" section on my OBD scanner app, even by then DTC section was empty and without any codes/errors.

By start of July, I got some money, I called my friend and we went to gas station, to refuel the car, once we reached gas station, we did put 100 octane (full reservoir top-up) and we did pass like 5 miles and car started to work very bad


Explanation:
  • It was like having block on rpm's
  • Couldn't pass rpm's
  • Not working on all cylinders
  • Could smell fuel around the car

I've scanned some codes and this is what I got, take a look: https://imgur.com/a/akLDEiK


I already purchased next:
  • Knock sensor & Wire set for knock sensor (AliExpress)
  • OEM Set of spark plugs


Will do:
  • Set of coils OEM (x6 total)
  • Clean fuel pump & it's components
  • Cleaning fuel injectors (x6 total) through UltraSonic method (I got them out of the car already)
  • Will check if there is any leak at valve cover under the spark plugs

Everywhere where I did ask for opinion (friends, gym, mechanics, etc)


Response was that, car has got clogged with trash from the fuel tank since car was below fuel level for last 4 months and that's issue for this misfires ?


Your opinion how to solve this ?


Thanks !

Last edited by AlligatorVS; Jul 30, 2024 at 08:25 AM.
Reply
Old Jul 30, 2024 | 06:16 PM
  #2  
phreaktor's Avatar
phreaktor
Design Engineer
iTrader: (22)
 
Joined: Jan 2007
Posts: 28,233
Likes: 33
From: The Marketplace
Default

Precise issues I had when I took my car (same year) off the road. I believe it is fuel related. Either water in the gas or trash sucked into the injectors. Because the car was in E territory for the longest and I kept moving it around until it only crawls now and yes fuel smell is what should be your red flag.

My plan is to have the injectors tested because I did all the coils and plugs. My **** is misfiring HARD. One other burgeoning concern is my valve cover spark plug seals. They all go bad eventually and on the OEM covers they're part of the casting. You have to replace the whole valve cover and the aftermarket ones with removable seals all go bad, I hear. Do you have what sounds like an exhaust leak near the left or right manifold?

Last edited by phreaktor; Jul 30, 2024 at 06:19 PM.
Reply
Old Jul 31, 2024 | 04:42 AM
  #3  
AlligatorVS's Avatar
AlligatorVS
Thread Starter
New Member
 
Joined: Jun 2024
Posts: 4
Likes: 1
From: SERBIA
Default

No exhaust leaks, my flex pipes we're damaged but I replaced them and at the moment, no exhaust leaks.
Reply
Old Aug 12, 2024 | 12:19 AM
  #4  
CassandraMorris's Avatar
CassandraMorris
New Member
 
Joined: Jul 2024
Posts: 2
Likes: 0
From: Utah
Default

All good now?
Reply
Old Aug 14, 2024 | 02:56 PM
  #5  
AlligatorVS's Avatar
AlligatorVS
Thread Starter
New Member
 
Joined: Jun 2024
Posts: 4
Likes: 1
From: SERBIA
Default

Originally Posted by CassandraMorris
All good now?
Well I didn’t fully put all back to start engine but I successfully replaced knock sensor & harness and I did quick ignition start and no more code in freeze frame & dtc section.

So, I’m waiting for fuel injectors to clean, then will put everything back and in meantime will replace spark plugs.

now I’m going to the garage to clean some stuff and will clean fuel pump too.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Colombo
Forced Induction
35
Nov 9, 2020 10:27 AM
StepZ
Maintenance & Repair
22
Feb 15, 2018 08:40 AM
Gohan49ers
Maintenance & Repair
8
Jan 8, 2018 05:44 PM
Zlut
Maintenance & Repair
2
Mar 24, 2015 04:23 PM
ffwturboZ
Maintenance & Repair
2
Nov 26, 2014 12:43 PM


Thread Tools
Search this Thread

All times are GMT -8. The time now is 02:08 PM.