Since I can't search the forum, does anyone know of a thread or anywhere on the internet that has step by step instructions on installing the popcharger?

 

I have a CAI so I don't know from experience, but doesn't it install just like a filter?

 

Theres a full set of instructions there.

http://www.jimwolftechnology.com/tech_details.asp

 

alright a few tips post installation...
- to take out the stock airbox its only 1 bolt shown in the instructions. the box will feel like its still bolted down but just pull hard and it will come loose
-i found it to be a PIA to get it all the way out but youll figure it out
-to make the holes to hold the heat shield dont use a screwdriver its a pain, use power tools. or heat up the end of the screw so it goes in easier. you probly wont be able to get the bottom screw in but the top one will hold it fine.
if the charger is resting on the shield try using a few washers on the bolt where the bracket goes to lift it up a little.

 

awesome, i can't wait to put it in tomorrow!

 

Don't wory about the holes you're supposed to drill. Someone recommended to me to not do them and I've been fine. Makes the whole install MUCH easier.

You'll love the popcharger

Hope this helps