small dimple on door panel casued by seatbelt buckle
#1
Registered User
Thread Starter
Join Date: Dec 2003
Location: san jose, california
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
small dimple on door panel casued by seatbelt buckle
Hello all,
yesterday I noticed a small dimple on the driver side door panel. The dimple was caused by the seatbelt buckle getting pinched between the seat back and the door panel itself when I closed the door the day before. After noticing that and adjusting the buckle, I expected the dimple to go away within a couple of hours or so, but this morning it's still noticeable. Has any of you experienced this problem, and will the indentation on the door panel go away after a while, maybe through a couple of "heat cycles", or should I expect it to be there permanently? Is there a "trick" to get the dimple out?
Thank you in advance for your input.
yesterday I noticed a small dimple on the driver side door panel. The dimple was caused by the seatbelt buckle getting pinched between the seat back and the door panel itself when I closed the door the day before. After noticing that and adjusting the buckle, I expected the dimple to go away within a couple of hours or so, but this morning it's still noticeable. Has any of you experienced this problem, and will the indentation on the door panel go away after a while, maybe through a couple of "heat cycles", or should I expect it to be there permanently? Is there a "trick" to get the dimple out?
Thank you in advance for your input.
#3
Registered User
Thread Starter
Join Date: Dec 2003
Location: san jose, california
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by ragtopz
as far as i know, it is permanent. i havent checked mine recently, but i know at the least, it lasts a long time.
as far as i know, it is permanent. i havent checked mine recently, but i know at the least, it lasts a long time.
Thread
Thread Starter
Forum
Replies
Last Post
CFAUVEL
Exterior & Interior
3
10-01-2015 03:20 PM
Extreme Dimensions
Southern California
0
09-24-2015 03:35 PM