I am planning on putting in the MM6 - Polk Audio 6.5" Momo components in the front and keeping my 10" sub in Zenclosure box. Full dynomat on both doors and no rear speakers.

My budget is fairly tight for this install and found this amp (TRX4.640 - Soundstream 4 Ch 640 Watt Amplifier) that I think can run both the components and the sub: http://www.woofersetc.com/p6755/TRX4...-Amplifier.htm

Will 100w to each component be enough to merrily drive the Polks and provide some solid mid bass? If anyone can suggest a better amp in that price range I would greatly appreciate it.

Thanks,

 

Bump for some advice. I need to make the purchase today to have the equipment for a Fri/Saturday install.

Thanks!

 

what sub?

i would suggest 150w to each set

 

http://www.woofersetc.com/p6837/DSC4...-Amplifier.htm
4 ohms: 125 watts x 4 chan.
2 ohms: 250 watts x 4 chan.
Bridged 4 ohms: 500 watts x 2 chan.

 

I am embarrassed to say but it's a Sony XS-L106P5B. I work for the company and it was a freebie so I may replace it for something better down the road. It's not all that bad considering that my mids are currently Bose.

I appreciate the advice on the amp and will be picking this one up.

Thanks again!

 

dont be embarrassed, you gotta start somewhere

now i wouldnt advertise it but im sure it will sound better than bose

 

For a little more you can get an Alpine pdx 4.100!

 

www.edesignaudio.com

Check out there NINe.2x amps