Upgrading Bushings
#1
Upgrading Bushings
I will be pulling off my front lower control arms to install some roll center adjusters. I have solid bushings on my 350-EVO upperA-arms. I would like to also get either solid/delrin/urethane bushings for the lower arms as well. The harder the better.
Are they available? Can someone make these for me? I think I remember a few machinists here on the board.
Are they available? Can someone make these for me? I think I remember a few machinists here on the board.
#2
Registered User
iTrader: (16)
Nismo has this kit:
http://www.mynismo.com/products/?id=5348#
I ordered just the lower transverse link bushings, it took like 6 months to get them (maybe they have them in stock now). I still haven't installed them...
http://www.mynismo.com/products/?id=5348#
I ordered just the lower transverse link bushings, it took like 6 months to get them (maybe they have them in stock now). I still haven't installed them...
#4
Nismo has this kit:
http://www.mynismo.com/products/?id=5348#
I ordered just the lower transverse link bushings, it took like 6 months to get them (maybe they have them in stock now). I still haven't installed them...
http://www.mynismo.com/products/?id=5348#
I ordered just the lower transverse link bushings, it took like 6 months to get them (maybe they have them in stock now). I still haven't installed them...
Trending Topics
#12
Former Sponsor
iTrader: (564)
Join Date: Feb 2003
Location: Long Island, New York
Posts: 19,266
Likes: 0
Received 5 Likes
on
5 Posts
Larry - there are no aftermarket bushings for the compression rod that I've seen (I just had to replace my rods since both inner bushings were torn). I did the lower control arm ones in my car as well
We have a bunch of the NISMO bushings in stock but unfortunately none of the front LCA ones
We have a bunch of the NISMO bushings in stock but unfortunately none of the front LCA ones
Last edited by Z1 Performance; 11-05-2008 at 02:41 PM.
#13
Registered User
iTrader: (46)
I purchased the noltec bushings but haven't gotten around to installing them. They also make a bushing for the lower front shock mount which I picked up cause mine are shot. Did that arm in the above picture fail because it was not allowed to move from front to back?
#14
Registered User
iTrader: (4)
Join Date: Jun 2005
Location: Right Here
Posts: 248
Likes: 0
Received 0 Likes
on
0 Posts
Did you buy the Noltec stuff here...
http://performanceshock.com/index.ph...ex&cPath=41_45
...or is there a better place?
http://performanceshock.com/index.ph...ex&cPath=41_45
...or is there a better place?
#18
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
Check out the new SPL bushings.
#19
Former Sponsor
iTrader: (564)
Join Date: Feb 2003
Location: Long Island, New York
Posts: 19,266
Likes: 0
Received 5 Likes
on
5 Posts
Yhere are plenty of people who have done the Whitelines now...Whiteline=Noltec btw We have them all listed on our site, as well as in the vendor classifieds if anyone needs
The new SPL's as mentioned are also sweet units and we've had great feedback from our customers who have purchased them. I'd say they are more track oriented though.
The new SPL's as mentioned are also sweet units and we've had great feedback from our customers who have purchased them. I'd say they are more track oriented though.