I've searched exhaustively (and can't find the old posts regarding this issue)...so here's the question.
I have 19x8.5 +15 Offset on the front (18x9.5 +20 Offset rear), and I want to drop my 03 with the gf210 to .6 Front and .7 Rear. Anybody know if the front will rub? I'd rather not pay for drop springs if they won't work.

Thanks in advance.

Zod

 

no I have same setting the 18X9.5 +12 all around. The front won't at all the read requires a small roll ... if you go +20 in the rear you doubt you will

 

Thanks man.

 

Why did you go with 18's in the rear? Do you have a pic of your old setup w/ the 19s? How come you changed them out?

 

GF210 should be 1'' front, 1.2'' rear, not .6 front and .7 rear. My quarter panel didnt rub with the +18 offset and 10.5 width, but I did roll my fender up a little.

 

WOW....been a really sh1tty week.... I didn't even realize tha tI typo'd....and I re-read for errors LOL. I am Running 19x8.5/19x9.5 (NOT 18s). I have also decided to do the Tein s-techs... I don't want a drop over .7/.8 range. My Z is my daily driver, and Joke-lahoma's roads are so bad, you could lose a 79 civic in the smaller pot-holes. I also don't wanna deal withcamber kits.
Thanks guys.