I've seen the word "junk" thrown around quite a bit when talking about the Kinetix rear camber and toe arms. Is the same to be said about the front camber kit?

 

I dont like the design/welds on their front arms and would never run them. Back in the day I had a Kinetix camber arm BREAK on the highway causing me to almost lose it-drivers side wheel must of had -6 degrees camber. It was an early production piece they sent me diff arms that were made of another metal and coated and no issues in over 2 years. Id go with Cusco or SPL arms...btw are you going for more negative camber or positive? Based off your answer you need to research what fits your needs better.

 

I was going to use them for bringing the camber back to normal once i lower it.