VIZAGE

iTrader: (20)

Anybody have any suggestion on how to better tighten the top nut on the a-arms. I know it's 27mm. And I do have it pretty tight. But it's hard to fit anything up in there to get the leverage. I don't have a 27mm wrench. But I have the socket that I tighten down with. Just not sure if it's to the desired 120lbs of torque it needs. There's little room for anything long to really get on it. Going for my alignment shortly, so maybe he'll have something. Oh yea, the front end of the car was lifted with all the weight off the front end and tire was off.

HR Autoparts

iTrader: (165)

i just installed my cusco a-arms dont remember any 27mm nut/bolt, all i used were 14mm i think for the 2 parts that connect to the body and the nut on the pivot joint is a 17mm

VIZAGE

iTrader: (20)

This is a nut that's on top of the a-arm that you losen and tighten to slid in and out to adjust camber. Cusco might be different. But we ende up getting it after searching for the right tool.