Ok I've done some searching on other treads and used the search fucntion which helped tremedously but didn't find exactly what i needed. Ok so my problem is my car went into the shop exactly 2 months and 3 days ago because i hydrolocked my engine and had to get it rebuilt.( a whole another story ) since my car was in there i knew it needed a camber kit due to an accident i had a couple months back, so when i got my alignment done to get the camber back to spec with the spc performance camber kit there now saying that my toe is horribly off. specified range is .01*-.09*, mine is at -2.65* I then proceed to tell them that the toe adjustment bolt has a 3 degree difference and they need to put that in along with elongating the toe slot. there trying to tell me that im going to have to start replacing upper control arms and the spindle housing and everything else that wasn't replaced after the first accident. I then tell them that I'm 19 I just replaced my engine does it look like i have any money left to start replacing all this sh**( and no daddy didn't buy the z for me unfortuently all payed for by me)
so my question is with that much negative toe is it possible with the spc kit to correct it cause there trying to tell me the the stock toe bolt has more range. any help would be greatly appreciated cause im about ready to give up on this car that i love so much cause for the past two months its been nothing but a nightmare. sorry for the rant thanks...