I recently was looking at a set of EVO A-Arms that were removed from a Pro Drifters car because one of the seats in the sperical bearings (the one that attatchs to the axle upright) was completely shot. The ball portion was very sloppy loose in the bearing. Has onyone else had this problem? I'm going to call up EVO and see if they can press a new bearing into the arm and if they can, will make the owner an offer to buy the arms.

 

I have the same problem but haven't pulled it yet for repair. Did EVO fix you up with a new bearing?

 

I am going to buy these from the current owner. I called EVO and they will sell a new plate with the bearing pressed in for $120.00

 

thanks for the info.