does anyone know if there is a DIY for the rear spl mono/knuckle ball bushing inatall for a tru coil w/o mid link
i tried searching here and google but cant find anything specfic to these bushing

 

Remove rear knuckle, press bushings out , press new bushings in , install knuckle back on car. Doesn't matter if your using the OEM spring bucket or SLP midlink. Got mine in today.

 

my dad through out my directons when cleaing out the garage to work on his painting project.

any chance you could identify which bushing goes where?
or no of a pdf fill
i check with spl and they didnt have one for this kit

 

Not listed on the directions, 4 of the bushings are the same, 2 are smaller , 2 are bigger. A cheap $10 micrometer will easily tell you where each bushing goes.