exedium rear camber arms
#2
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
Made in china where all the other cheap arms are. Probably ok for use, for $80 its cheap to find out.
#4
Registered User
Thread Starter
Join Date: Jun 2010
Location: NW indiana
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Ok well they were cheap so I didn't mind takin the hit too much...but these are advertised on vex motorsports and the description for them is wrong. It states it will put camber back in spec for lowered cars up to 2" but these arms are made to add camber..go figure. So I'm sending them back and getting a refund....live and learn I guess
#5
Registered User
If the wheel is tilted in at the top, the camber is negative. That's what you get when you lower the car with the stock arms.
You need to shorten the lower arm to get the wheel closer to being vertical (going from too much negative to just a little negative), so I suppose that would be "adding" camber.
You need to shorten the lower arm to get the wheel closer to being vertical (going from too much negative to just a little negative), so I suppose that would be "adding" camber.
Last edited by winchman; 04-16-2011 at 01:28 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Lt_Ballzacki
Brakes & Suspension
39
08-06-2021 06:19 AM
350Z Project X
Suspension
9
10-10-2015 09:23 AM