Rapid Prototyping Race Car Parts
#41
Registered User
Thread Starter
Join Date: Jan 2010
Location: Minneapolis, MN
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Hi Randy, I think I met you at PRI??
Hi, I've been making ducts like the long ones (I call them Intermediate because they're in between the nose and the backing plate) for Subaru's for a few years now. I've been testing a new concept that takes a lot of the complexity out of the cooling tract and replaces good old passive momentum with electronics. The side benefit is less drag with a small decrease in undercar pressure as the fans grab the air and spit it out the wheels.
#43
Registered User
Thread Starter
Join Date: Jan 2010
Location: Minneapolis, MN
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
#44
Registered User
Thread Starter
Join Date: Jan 2010
Location: Minneapolis, MN
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Update on winter progress:
Prototype out of ABS
3D printed composites tool out of hightemp Ultem material
Carbon layup
Printed a trim guide out of durable Nylon material
Installed on car
Prototype out of ABS
3D printed composites tool out of hightemp Ultem material
Carbon layup
Printed a trim guide out of durable Nylon material
Installed on car
The following users liked this post:
KingBaby (04-08-2016)
Thread
Thread Starter
Forum
Replies
Last Post
etkms
Engine & Drivetrain
29
06-19-2022 06:30 PM