hey guys just finished lowering my car on some eibach sportline springs and in the past when i tried to do an alignment they told me my rear camber was out of manufacture specs and i was like ok thats fine and so i ordered some spc rear camber kit and i was wondering if i want more negative camber when i install it will it give me the negative that i want? has anyone used this brand? and if possible do i thread out the nut as far as it goes to get negative camber? best degree for camber? thanks guys

 

You already achieved negative camber by lowering your car without aftermarket camber arms. But to answer your question, yes, if you install SPC camber arms you can add more negative camber or go back to factory specs by adjusting the nut.

 

thank you advanz33

 

Why would you want more rear negative camber? Once past the OEM specs of -2.1 the rear traction starts to deminish quickly

 

Because he wants to be one of the cool kids and have his Z look like this:

 

I feel myself losing brain cells by looking at dcains' picture

 

but dcains is prob right, op wants to be in the camber gang (because running on half the tire makes total sense)

 

Half of the already too narrow tire because we all know op is going to be putting a 225/35 tire on an 11" wheel

 

It's actually going to look worse because his car isn't going to be that low. It should be a great time.