FS: Stoptech BBK calipers and hats front/rear
Thread Starter
Registered User
Joined: Feb 2013
Posts: 15
Likes: 0
From: Victoria BC
Stoptech BBK calipers and hats front/rear
Edit for new, bottom-line price: $1100 shipped.
This is a front/rear set of brake calipers, caliper brackets, and hats. The rotors were machined incorrectly and have been discarded. The calipers, pads, and the rotor "hats" are fine.
Front rotors are 355mm x 32mm. Rears are 328 x 28 (also seen advertised as 330 x 28 - same rotor). Front calipers are 4-piston, and rears are 2-piston. This kit will fit on any G35 or 350Z with 18" sport coupe wheels or bigger. It WILL NOT fit with 17" wheels or 18" sedan wheels.
10,000 street kms, never tracked. Powdercoating was peeling (see pic) so I repainted them while protecting the original logos. Of course brake fluid hates paint so if you want these to look brand-new you might want to consider powder-coating. If you don't care, then these are good to go.
The friction rings are NOT included, which is why I'm not asking for $1800+ for a set of four Stoptech BBK components.
You will need to replace the friction rings of the rotors in order to install this kit on your G or Z. Even with that expenditure you're saving over $1500 compared to a new kit. You will also need to reuse your OEM brake lines or upgrade to stainless ones (not included). Rear pads have lots of life left. Fronts *should* be okay but might have uneven wear due to the warped rotors. Probably a good idea to get new pads when replacing any rotors, anyway.
http://www.picpaste.com/IMAG1338-vsU3EPid.jpg
USD$1100 shipped anywhere in the Lower 48 or Canada. Priced for quick sale.
I will NOT sell the fronts separately, but if you want just the rears I'd let them go for $800.
Email me as I don't get on the forum often: theironyuppy@hotmail.com
This is a front/rear set of brake calipers, caliper brackets, and hats. The rotors were machined incorrectly and have been discarded. The calipers, pads, and the rotor "hats" are fine.
Front rotors are 355mm x 32mm. Rears are 328 x 28 (also seen advertised as 330 x 28 - same rotor). Front calipers are 4-piston, and rears are 2-piston. This kit will fit on any G35 or 350Z with 18" sport coupe wheels or bigger. It WILL NOT fit with 17" wheels or 18" sedan wheels.
10,000 street kms, never tracked. Powdercoating was peeling (see pic) so I repainted them while protecting the original logos. Of course brake fluid hates paint so if you want these to look brand-new you might want to consider powder-coating. If you don't care, then these are good to go.
The friction rings are NOT included, which is why I'm not asking for $1800+ for a set of four Stoptech BBK components.
You will need to replace the friction rings of the rotors in order to install this kit on your G or Z. Even with that expenditure you're saving over $1500 compared to a new kit. You will also need to reuse your OEM brake lines or upgrade to stainless ones (not included). Rear pads have lots of life left. Fronts *should* be okay but might have uneven wear due to the warped rotors. Probably a good idea to get new pads when replacing any rotors, anyway.
http://www.picpaste.com/IMAG1338-vsU3EPid.jpg
USD$1100 shipped anywhere in the Lower 48 or Canada. Priced for quick sale.
I will NOT sell the fronts separately, but if you want just the rears I'd let them go for $800.
Email me as I don't get on the forum often: theironyuppy@hotmail.com
Last edited by TheIronYuppy; Aug 4, 2013 at 09:21 PM.
Thread Starter
Registered User
Joined: Feb 2013
Posts: 15
Likes: 0
From: Victoria BC
Thread
Thread Starter
Forum
Replies
Last Post