i live in Northridge and am wondering whats the nearest 1/4 drag strip?

do u guys think 11sec is reachable with my following mods

PE-tt 477whp 490wtq @12psi built short block/ toyo R888 F265 R295 what tire pressure should i keep the tires at !

 

I ran 11's with less than 400whp that would be easy at your power levels.

There is a STICKY race track locator at the top of this page btw

 

appreciate u help Alberto

what would be a idle RPM launch 3k ? more or less !

 

yeah, i went 10.9 at 130 with 475 and a gutted car....

stock 6 speed.


its very possible..

 

very impressive 10.9

 

It depends on traction and how good you are with the clutch. I know experienced guys launching at 5k plus on a good track and good skills.

 

You are using a road race tire for drag racing. If you are serious about putting down some good times, you should get another set of wheels/tires for the rear.

 

i want to know what could i get with those R888 as far as road racing with these tires at my power level i hardly have a tire spin so, thats why am going to the track with these tires. but thanks for the tip

 

its actually my first time driving at drag strip so, i think i take it easy at first then go from there to higher RPM.

i know u driving skills are incurable ridicules almost sub 11sec with only 400whp thats sick. u where using MT right

 

NOPE...A/T for me

 

Hey whatsup man, nice build, finally done I knew gtm did good work.

Be sure to get some videos at the track

 

sure thanks,

in fact am going tomorrow morning @ 8 am to cali-speedway Pacific Street Car Association (PSCA) Event May 16th - 18 . let u know what time am gonna run with this setup.

do u guys have any tips for me

 

i ran 13.4 @ 110mph .... lunched at 4000rpm which made the car totally lose at 1 and 2 gear the car is shaking like crazy at 1st maybe wheel hope not sure but by the time i got it in 3rd the car start pulling really good...

also its my first time EVER at drag strip and i just had a chance to race ONCE because of helmet


any advice on how to improve my driving

 

with 12psi setting

 

Post a slip. That is a horrible trap for the power level. We need more details to help you out!

 

I will not criticise your time. You are new at drag racing. I am sure that you gave it your best. We have plenty of 477 horsepower dyno queens here who could not run 13.4 seconds if their life depended on it.

 

my time slip

 

i cannot rotate my head enough to read that upside down lol

 

lool

R/T .546
60' 2.313
330 6.114
1/8 8.979
mph 85.10
1000 11.375
1/4 13.401
mph 110.83

no u don't have to :P

 

OK, well you know the 60ft needs work

What pressure in tires?

Did you do a quick spin of the tires after going AROUND the water box?

Did you shift at redline?

You need to be your worst critic. Thats how I got better at driving Id critique myself until I felt I couldnt possibly shift any faster. Get back out and run better times they wont get worst than your first time