Setup with PBM SAK kit
#2
Registered User
iTrader: (2)
Join Date: Feb 2006
Location: Florida
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
First find someone who knows there stuff when it comes to alignments. I took it to two different guys who said they could do it 8 hours later they couldn't do it. I finally found a guy gave him my specs and 4 hours later its perfect.
front -3 camber
toe 1/8 out
caster +8
rear 0 camber
toe 0
front -3 camber
toe 1/8 out
caster +8
rear 0 camber
toe 0
#5
Registered User
iTrader: (2)
Rear
1/8 - 1/2" toe-in depending on how the car slides sideways vs traction. Use tire pressure for sidebite adjustment and add toe for more fwd bite.
0 camber or plus 0.5 if you have lot of grip/body roll/squat.
Front with PBM
Pull back caster closer to 7 or high 6 by shortening the diagonal arm "banana shaped arm", this will stop overcentering once you shaved the spindles to get max angle out of the kit.
Front toe:
1/16" total out for fast drifting.
1/4" total out for slow drifting (front of car will turn a tighter radius).
Front camber: -4.5 ish.
1/8 - 1/2" toe-in depending on how the car slides sideways vs traction. Use tire pressure for sidebite adjustment and add toe for more fwd bite.
0 camber or plus 0.5 if you have lot of grip/body roll/squat.
Front with PBM
Pull back caster closer to 7 or high 6 by shortening the diagonal arm "banana shaped arm", this will stop overcentering once you shaved the spindles to get max angle out of the kit.
Front toe:
1/16" total out for fast drifting.
1/4" total out for slow drifting (front of car will turn a tighter radius).
Front camber: -4.5 ish.
The following users liked this post:
nichols (09-01-2015)
#10
Registered User
Join Date: Dec 2010
Location: Austin, TX
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Left Front:
Camber: -3.8
Caster: 6.4
Toe: -.01
Right Front:
Camber: -3.7
Caster: 6.1
Toe: -.01
Left Rear:
Camber: -1.8
Toe: .07
Right Rear:
Camber: -1.8
Toe: .06
#11
Registered User
Since the kit allows the knuckle to pivot about a single point instead of 2, our scrub radius increases considerably! My front wheels are 9.5" wide and have an offset of 0 (my scrub radius is out of control now). The first time I got sideways with the kit, the car felt very twitchy and sensitive. Didn't slide near as smooth as it used to
I want to ask what front wheel widths and offsets some of you guys run.
I want to ask what front wheel widths and offsets some of you guys run.
Thread
Thread Starter
Forum
Replies
Last Post