A few of the brackets ripped off that plastic piece, so my diffuser is half hanging off on one side... i have zip tie to hold it up for now.

1) what is that plastic piece called
2) how much to replace?
3) where can i get one?

thanks!

 

Do you need to replace the 10 mm screws or the plastic undertray?

Both will more then likely have to be purchased from the dealer..

 

oh that's the term.. yah it's the plastic under tray that's ripped.... 2 of the 'nut' side that's attached to the plastic under tray ripped right off so it's pretty messed up right now.

the zip tie's ok but it's pretty messed up and it'd be nice if i can replace it but i know the piece includes the wheel well and i think i read somewhere it can cost quite a bit :S

 

You may want to post up a WTB thread... I may have one for you, but I cant confirm until friday.

Church

 

If it's ripped, it's best to replace it. I recall mine still flapping on highway even with zip-ties. I'm sure it messes up some "aerodynamics"

 

thanks for the replies...

here's what my friend told me

part# 75892 : lower engine cover

I believe that's what it is, it's 130 MSRP ... i can get it for 90

Can someone confirm that's the part#? the name sounds about right but i want to be sure. I tried to look for a diagram but i couldn't find it in the service manual i downloaded.

thanks again!

 

I'm looking for this too... I can't see to find it for sale anywhere on the internet. I've found aftermarket aluminum but its like $500!

Where are you getting it from for $90???