Just incase anybody thought about getting one of these, or spilling the cost and doing a few buddies cars, check out the attached ad in the latest Princess Auto flyer. Thats the same unit that was used on my car to roll my fenders and it did a really nice job, no cracking, scratching or anything like that.

It bolts onto the wheel hub and you set the angle of the red wheel against your fender. The handle runs it around the fender in a perfect circle. You just increase the angle of the red wheel at the top a bit each time and run it back and forth slowly bending the lip up. You don't need to bend it flat, most of the time a slight bend of 45* is more than enough to clear wide wheels.

 

where did u get yours done .too much $$$ for one time use ..or somebody wanna share with me..... i have to do mines asap......

 

looks exactly like the one eastwood sells (made in china)
I think i paid a total of $294 for mine when i ordered from eastwood.

 

If your in markham, call up Speedstar, they can do it for you. Or if they are busy, and you don't mind driving, go by APH.