Looking for a shop in the west end to install some rear camber arms and SPC Toe bolts for me. Would go to APH if I could but with the G20 stuff happening this weekend it's gonna be real tough to get out there. Need a place in the Oakville, Mississauga, Milton area. Let me know if you guys have any suggestions. Thanks.

 

G20 doesn't cover the APH area....

 

Your right it doesn't... but i'm just more concerned with the traffic chaos its going to cause on the 401. Wouldn't want to spend most of my weekend sitting in grid lock on the highway.... i spend most of my weekdays doing that already.

 

take streets, it will be quicker, or go around 11am or so everything is cleared out by then, even if they close a lane or two...

 

SG Motorsport in Brampton.

 

We specialize in suspension setup, alignments and corner balancing.

No where in the GTA will you find corner balancing and an alignment for less than at SG, and we align withing 3 one HUNDREDTHS of a degree!

 

im planning on installing my spc camber kit and toe bolts soon too and i wanted to know how much does it cost to get my camber and toe back in spec and alignment??? and i might think bout doing the corner balancing also...PM if needed

 

Kudos to Sasha and his crew. I had an alignment done at SG last week and was very happy with the service that was provided. Sasha is extremely knowledgable and a great guy as well



Thanks again!

 

Wow this is an old thread. I actually did end up getting everything done at SG. Sasha's a real stand up guy and I was very satisfied with the entire experience. Definately my shop of choice from now on. Thanks Sasha

 

Sasha, do you advise people not to get SPC stuff?

I know you've seen it break right on the shaft and so have i..

 

SPC blows... I have them and I'm going to buy SPL when I get the extra cash.

 

good man... SPL is 100x better than SPC.

i'll be getting into a G35 soon and will then finally develop some of my own stuff for the chassis