Probably won't be using these again so seeing if anyone wants them.

They are 2 layer plain weave, with a top layer of twill (3 total) with west systems epoxy. The passenger side was coated in extra resin so it has a 'glossy' look, where the drivers side was left 'dry'. Both have had a shot of clear coat already but you could lay up resin on them again if you wanted to.


Pics below, but I should point out that these replace your headlights, which is what your bumper attaches too. You would either need to make a small bracket to hold your bumper on (lots of places to attach it to under there), or attach the bumper in another way (I used aerocatch pins).

Or since these were made FROM headlights, they would actually snap right ON headlights, if you wanted to use them as headlight covers at the track. I haven't tried this, but they would fit right on. As headlight deletes they fit well, probably could use better brackets if you don't want to seal them with tape.


Price is my material cost, $80 + shipping.

 

They fit well, I have a set from Crom.

 

Pm me your PayPal I'll take them now

 

Just to confirm, I made these myself.

Do you want me to ship to Miami? It would be at least $20 in shipping I would guess. Price is in $CND