Need advice/help on this. One of my turbo cars (200sx w/. jdm bluebird sr20det red top Gti-r engine swap) needs a custom mandrel bent pipe. I currently have it here and it actually hit a nasty pot hole and got pinched together. I tried banging it out but to no avail. If there is anyone on the forum wit a greddy tt or any tubo cars and has gotten custom pipes done before please let me know where you have gone for a good price. I am located in NJ but will ship. Its just one pipe i think 2.5 inchs if I remember correctly about arms length if it was straightened out.
Thank You

 

The process goes like this:

Figure out what degree bends you need and order the bends from BurnsStainless.com. Then you have to cut them to length with a chop saw and have them welded together.

Generally the bends will be 45, 90, 180, or 15 degree bends.

Chris

 

See www.jotechracing.com , he did all custom job on my car. I am sure you can order the part you need from him.