Spark Plug change after reflash question
Thread Starter
Registered User
iTrader: (1)
Joined: Jun 2004
Posts: 448
Likes: 0
From: Massachusetts
Ok everyone I hope this is not a dumb question, but if i get denso iradium plugs over my factory NGK platinum plugs will that mess up my reflash. Im just wondering this because I had my car tuned with platinum plugs not iradium, and im wondering if this would make a difference tune wise.
Thanks Glen
Thanks Glen
Last edited by Zmego1985; Apr 16, 2006 at 07:18 AM.
I doubt it will affect the reflash. Just becareful to get the spacing on
iridium plug right; that could cause the loss of performance.
BTW, which reflash did u get? AA or Technosquare?
You should go dyno the car just in case. When I reflashed my
car I actually lost power.
iridium plug right; that could cause the loss of performance.
BTW, which reflash did u get? AA or Technosquare?
You should go dyno the car just in case. When I reflashed my
car I actually lost power.
Thread Starter
Registered User
iTrader: (1)
Joined: Jun 2004
Posts: 448
Likes: 0
From: Massachusetts
I got AAM's reflash in house. I had Mike dyno tune my Z. I believe thats the best way if your going to get a reflash, because when i had Technosqaure reflash my ecu I had nothing but problems sending it out.
Thanks Glen
Thanks Glen
Thread
Thread Starter
Forum
Replies
Last Post




