Pulley Install Q
#3
Registered User
Join Date: Dec 2003
Location: Midland, TX
Posts: 1,602
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by undrgnd
I placed a leather glove finger around a screwdriver (to keep from scratching the engine) and pushed it thru the pulley against the block.
Thats basically what you have to do. I did the same thing but it was a little easier for me since I have access to a lift.
#4
Originally Posted by BluZee
Thats basically what you have to do. I did the same thing but it was a little easier for me since I have access to a lift.
Last edited by Cannysage; 05-13-2006 at 02:05 PM.
#7
Registered User
Join Date: Dec 2003
Location: Midland, TX
Posts: 1,602
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Cannysage
Mine was jammed like no others. I went throught 2 screwdrivers (bent all out of hell) and snapped 2 rachet extentions. I finally got the bolt off after jamming a wrench and putting enormous amount of torque power (with 2 feet pipe), and now can't get the crank off.... any suggestions?
Thats weird, mine came right off.
Thread
Thread Starter
Forum
Replies
Last Post