hr2burn

iTrader: (1)

I have a ACT Prolite Flywheel with a Jim Wolf clutch assembly. I have an issue with the throw out arm. The slave clyinder has to move about 5/8" before it even contacts the throw out arm leaving very little movement to disengage clutch. Did all kinds of clutch pedal adjustment, no help. It's as if the whole clutch/flywheel isn't thick enough and there is slack because of this. I'm sure someone else has this setup.
Help!!
Sean

Ninja350Z

I have the ACT HDSS clutch and ACT pro flywheel never had any issues with it.

kramykram

iTrader: (135)

Not sure what the problem might be. But other than that how does it engage is it smooth. Reason I ask is I had a problem with my old z32 doing this it was with a stillen flywheel and jwt clutch. I took a pushrod out of a v6 I had here and measure it up, cut it down and rounded the tip off. I put a vacuum line block off a carburator, and use that for the tip and it worked fine for me after. Not sure whats going on but its an idea