My pigtail (electric plug-in) that goes onto the oil pressure sensor was damaged.. long story short, I'm trying to figure out the wiring configuration on this pigtail so I can read my oil pressure. Nissan, of course, does not sell the pigtails independently, they want me to purchase an entire new ECM harness.

Picture as shown below, if someone has a moment to look at their oil pressure sensor, and tell me how the wiring goes into the back of the plug (example: yours is: from left to right, clip side up, red, black, blue). I'm at work, and don't recall the colors, so yours may vary...

Any info would help so I don't have to empirically test each combination on my own (granted, there are only 6 ways this combination could go, but, ya know...)

 

It's red, green, black, left to right, if the pointy part is facing UP, clip facing DOWN.

 

Awesome - thank you!

 

Any excuse to get under my car