MSD Tach Driver install ?
#1
Registered User
Thread Starter
iTrader: (1)
Join Date: Sep 2009
Location: Arlington, WA
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
MSD Tach Driver install ?
Hello to all, I've been running around my completed 350sx (92' 240sx with 04' 350z VQ35DE) for a while now but without a working tach and now I'd like to button that up lol.
So I've got the MSD Tach Driver box, got a good ground and switched 12v where needed, and the grey goes to my gauge, basically I'm just trying to figure out the signal input wire.
I tried using the white/blue stripe wire in/out but that did nothing but made the passenger side cylinder bank not fire, any more suggestions? I was thinking of trying the Yellow/Red. Anyone install one of these? Thanks in advance!
So I've got the MSD Tach Driver box, got a good ground and switched 12v where needed, and the grey goes to my gauge, basically I'm just trying to figure out the signal input wire.
I tried using the white/blue stripe wire in/out but that did nothing but made the passenger side cylinder bank not fire, any more suggestions? I was thinking of trying the Yellow/Red. Anyone install one of these? Thanks in advance!
#2
Registered User
Thread Starter
iTrader: (1)
Join Date: Sep 2009
Location: Arlington, WA
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
Has anyone else installed one of these? If I get time and or figure it out before I'll be sure to post up which wire it is, seems like it's nowhere to be found in the internet lol
Thread
Thread Starter
Forum
Replies
Last Post
Gruppe-S
Body Interior
13
05-16-2016 10:42 PM