When I bought my z it didn't have a strut tower bar so I just purchased one.does anyone know what size and pitch the nut is that holds down the bar.thanks

 

you might want to order them through the nissan dealership, they'll know the part numbers.

 

This might be a shot in the dark as I don't have one in front of me right now but I believe the bolts are 10mmX1.25, unsure about the length. Best bet is to swing by the hardware store and pick up a couple different lengths, test what fits then buy em up.

 

^ I agree.........autozone sells packs of 2 to 4 in Grade 10.9..........usually you can grab a pack and go outside while they hold your hand or watch you and you confirm...

one is a nut on each side..........3 others are bolts..

I would say about 40mm long or so..

I would start with M10x1.25x40mm like Brett mentioned...

Nut:


This pic i grabbed from another thread shows the 3 other bolts:
(WHITE ARROWS - TOP LEFT ONE IS THE NUT)


-J

 

Ok will do..Im working crazy hours so its a little hard to run back and forth to az...but probably this weekend I'll have a chance..I appreciate it guys

 

I hate that nobody confirms here like why start it in the first place

 

Easy tiger. The question has been asked many times if you search. M10-1.25x30mm.

Good on you for the zombie thread bump to voice your discontent.