So I managed to score a used clutch kit from someone from eBay. He claimed it had only 10k miles on it. It's a $600 6 puck act and I scored it for 100 bucks. Add that with my exedy flywheel (never installed) that I got for 100 bucks and I have a $1000 clutch/flywheel combo for 200 bucks if it works.

As far as the clutch goes, I really ain't sure what I'm looking at to know whether or not the thing is useable. That's where you fine gents come in. To me it looks great. Aside from being slightly dirty, but I'll leave the final word to you guys. Here's some pics I have, I don't have any right now any closer, I'll take some more when I get off work.

 

I can't speak for the condition of the clutch but the only 6-puck (that I see) that uses the N021 pressure plate is this one:
http://www.advancedclutch.com/nz1-hdg6

Just so you know what you're installing. Good luck.

 

I this not it?

http://intensepower.com/act6heduclki.html

I wonder if I can buy the full disk plate and use that with the n021 pressure plate instead of the 6 puck. There's no way I need a 6 puck clutch.

 

Those are the only 2 that use the N021 PP

 

Lol oh. Ok.

I'm going to order the rest of the parts for install from z1motorsports, since I'll be all up in it anyway.

Cast iron clutch release fork
Throw out bearing sleeve retainer spring
Release fork retainer spring
Chromoly release fork pivot ball
Throw out bearing sleeve
Release fork dust boot
Koyo throw out bearing
Nismo pilot bushing needle bearing
S/S clutch line
Alignment tool

Anything else you guys can think of to get this done?

Is there anywhere I can get all the fasteners for this mess? Flywheel included?