car won't rev past 1000 rpms
#1
Registered User
Thread Starter
Join Date: Mar 2015
Location: Illinois
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
car won't rev past 1000 rpms
I have a 2005 Mt 350z and I went to start my car today and it took a few times and I had to give her gas to get her going. All the lights came on and it wouldn't Rev past 1000rpms. No power what so ever. Recently cleaned my throttle body (didn't touch the butterfly) and did cam positioning see sensors. I turned the car off then on and gave her gas again and the slip and traction control light turned off and just the check engine light remained but the car had full power. Any suggestions? Asking because I don't want to drive her and mess something up.
Last edited by Bamdon16000; 03-13-2015 at 10:19 PM. Reason: left things out
#3
Registered User
Thread Starter
Join Date: Mar 2015
Location: Illinois
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Yeah it was the tps sensor. I replaced the throttle body unit. Do you happen to have th throttle relearn for a 2005 manual Trans 350z by any chance. Now it revs high around 1500 rpms and when I give it gas it keeps accelerating even after I release to around 3k
#5
General & Tech Moderator
MY350Z.COM
MY350Z.COM
I have a 2005 Mt 350z and I went to start my car today and it took a few times and I had to give her gas to get her going. All the lights came on and it wouldn't Rev past 1000rpms. No power what so ever. Recently cleaned my throttle body (didn't touch the butterfly) and did cam positioning see sensors. I turned the car off then on and gave her gas again and the slip and traction control light turned off and just the check engine light remained but the car had full power. Any suggestions? Asking because I don't want to drive her and mess something up.
#6
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
Throttle body cleaning seems to hurt these cars more than it ever helps
#7
I have a 2005 Mt 350z and I went to start my car today and it took a few times and I had to give her gas to get her going. All the lights came on and it wouldn't Rev past 1000rpms. No power what so ever. Recently cleaned my throttle body (didn't touch the butterfly) and did cam positioning see sensors. I turned the car off then on and gave her gas again and the slip and traction control light turned off and just the check engine light remained but the car had full power. Any suggestions? Asking because I don't want to drive her and mess something up.
was your car not passing a certain rpm and also your slip and tcs light turned on and wouldn’t go up to speed? Lmk please TIA
Thread
Thread Starter
Forum
Replies
Last Post
etkms
Engine & Drivetrain
29
06-19-2022 06:30 PM
AbyteZero
Engine, Drivetrain & Forced-Induction (DIY)
3
09-22-2015 09:17 AM