P0300 after fitting decats
#1
Registered User
Thread Starter
Join Date: Oct 2016
Location: Swansea
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
P0300 after fitting decats
Hi all I have a 2003 Nissan 350z with about 116500 miles I installed invidia de-cat stillen y pipe and agency power back box just a week after installing I have p0300 fault code.
I was driving down the road fine and all of a sudden it just sounds like not all the cylinders are working but it come and goes on cold start it's fine for about 30 seconds then it goes again and sounds like a Subaru boxer engine.
Could someone please tell me if I have caused this by installing the decats without a remap or is it something else
Thanks in advance
I was driving down the road fine and all of a sudden it just sounds like not all the cylinders are working but it come and goes on cold start it's fine for about 30 seconds then it goes again and sounds like a Subaru boxer engine.
Could someone please tell me if I have caused this by installing the decats without a remap or is it something else
Thanks in advance
#6
New Member
You're probably running too lean. Get it tuned sooner rather than later.
Thread
Thread Starter
Forum
Replies
Last Post
bthezman
Suspension
0
09-06-2016 11:42 AM