Well since the search feature is down I've had a hella a time trying to find some sort of guide to installing a injen CAI. Anyone happen to have a link or kind enough to post some helpful guide lines? I've seen it mentioned that the bumper removal is optional(my prefered method).

Anyone able to share some light on the subject?

 

Don't know about the Injen intake but, could you tell us more about the 50th Anniversary 84 300zx in your sig?

 

There should have been directions with the intake. Its pretty easy to follow, the pictures help as well. I didn't have to remove the bumper, but i did take out a couple clips on the top of the bumper so i could pull it back a little. There are also some tight places to reach, like the heat shield, but its not bad. If you need more install help, hopefully the search feature gets back up, cause there are a couple install guides on here.

 

The 84 Z I really don't know too much, it used to be my fathar's car, his 2nd car actually. It's a very heavy paper weight now that it dosn't run.

I bought the CAI used from skidazle so it didn't come with any form of written instruction. Any additional input would be greatly apprecaited.

 

Oh. Well, trying looking at **********.com, i think thats what its called. Or zchicks.com, i think there are install instructions on one of those.

 

Here you go Z Pride. These directions are actually better than the ones you get from Injen.

www.overboost.com/story.asp?id=1085

 

Jovasi - Thanks for the link, I greatly appreciate it.

 

Jovasi
thx again