I just purchased and began installing the Crawford Cats. I didn't get any instructions or receipts. Just great! Does anyone have a good method of getting those sensors out without damage? I would call Crawford but I don't know if they would tell me since I got a box with no paperwork.

 

just use the right size wrench . Un hook the elec. connections first

 

quick questions if you forget to unhook the electrical part first and take out the sensor first will that mess it up an dcause the ses light to come on?

 

No, I figured it out and unhooked the electrical first.

Thanks,

Mike

 

If the sensors are being real stubborn? you could heat up the hex part or right below the hex with a touch, so that the material expands.

 

I was able to install them last night. Just took a while.