Splicing or tapping into ECU wires
Thread Starter
Joined: Mar 2004
Posts: 3,996
Likes: 76
From: JC in Atlanta Georgia
Splicing or tapping into ECU wires
What is the best way to tap into the wires in the ECU harness?
Cut the wire, solder, and tape or shrink tube? (This can be a pain if there is little space)
Are squeeze-on wire taps any good (reliable)?
Cut the wire, solder, and tape or shrink tube? (This can be a pain if there is little space)
Are squeeze-on wire taps any good (reliable)?
Registered User
Joined: Oct 2002
Posts: 301
Likes: 0
From: Melbourne, FL
have you seen one of these:
search on ecu wire harness: https://my350z.com/forum/showthread....u+wire+harness
http://www.autosportwiring.com/pages/1/index.htm
search on ecu wire harness: https://my350z.com/forum/showthread....u+wire+harness
http://www.autosportwiring.com/pages/1/index.htm
Registered User
Joined: Jul 2003
Posts: 1,671
Likes: 0
From: Albuquerque, New Mexico
I would check to see if "autosportwiring" has released their harness! If not, then cut, slice, solder and shrink wrap. You want to do it once and not have to get back under the dash and pull the ECU.
Thread
Thread Starter
Forum
Replies
Last Post
350Z_Al
Exterior & Interior
133
Oct 29, 2020 07:44 PM
