Clutch pivot ball height
Thread Starter
Registered User
Joined: Jun 2016
Posts: 2
Likes: 0
From: New Jersey
Clutch pivot ball height
I am in the middle of an installing a spec super twin clutch (part# Sn35sst) I toasted the JWT clutch.
I know that the throw out bearing should be right on the pressure plate and mine is not, to achieve this you would need to increase or decrease the length of the pivot ball
has anyone done this install?
i am trying to avoid taking the trans in and out multiple times to find out the correct measurement, I have a factory slave cylinder, I am doing this in my drive way and any help would be appreciated.
I know that the throw out bearing should be right on the pressure plate and mine is not, to achieve this you would need to increase or decrease the length of the pivot ball
has anyone done this install?
i am trying to avoid taking the trans in and out multiple times to find out the correct measurement, I have a factory slave cylinder, I am doing this in my drive way and any help would be appreciated.