FS: Full Haltech Package!! EMS, WB,BCS, 3bar MAP, gauge
Thread Starter
New Member
iTrader: (11)
Joined: Oct 2007
Posts: 8,807
Likes: 7
From: raleigh-wood NC
Hey guys,
Putting my full Haltech setup for sale.
Its 1 stop shopping for a killer deal.
You get everything you need for your boosted motor!
-Haltech PnP EMS.
-Haltech wiring harness. already setup for dual wideband controller and wires already for a switch on pin 101 so you can brake boost
-Haltech dual wideband controller with BRAND NEW wideband sensors. The sensors just cost me 150$ by themselves! The harness has also been extended about 4' to accommodate widebands in the downpipes.
-Haltech dual wideband gauge: so you can monitor both banks AFR from 1 gauge (pod not included)
-3 BAR MAP sensor
-Haltech boost control solenoid: no need for aftermarket boost controller. 100% controlled by the haltech.
Taking a bath on this, so willing to sell everything for 2100$shipped. (+3% paypal fees if you decide to use a credit card)
Not parting anything out for the time being.
I'll include all the terminal blocks and detailed instructions to get you all wired up in no time.
Any questions, feel free to PM me!
Putting my full Haltech setup for sale.
Its 1 stop shopping for a killer deal.
You get everything you need for your boosted motor!
-Haltech PnP EMS.
-Haltech wiring harness. already setup for dual wideband controller and wires already for a switch on pin 101 so you can brake boost
-Haltech dual wideband controller with BRAND NEW wideband sensors. The sensors just cost me 150$ by themselves! The harness has also been extended about 4' to accommodate widebands in the downpipes.
-Haltech dual wideband gauge: so you can monitor both banks AFR from 1 gauge (pod not included)
-3 BAR MAP sensor
-Haltech boost control solenoid: no need for aftermarket boost controller. 100% controlled by the haltech.
Taking a bath on this, so willing to sell everything for 2100$shipped. (+3% paypal fees if you decide to use a credit card)
Not parting anything out for the time being.
I'll include all the terminal blocks and detailed instructions to get you all wired up in no time.
Any questions, feel free to PM me!
Last edited by str8dum1; Apr 28, 2011 at 07:31 AM.
Thread Starter
New Member
iTrader: (11)
Joined: Oct 2007
Posts: 8,807
Likes: 7
From: raleigh-wood NC
ya still in the car. would take a day to get out. I've had the haltech for 1.5 yrs but the cars only been running for less than 10hours during that time because I blew up the engine.
Last edited by str8dum1; Apr 28, 2011 at 07:33 AM.
Trending Topics
you traitor!
going for the proEFI huh? I wish i could take the hit and jump ship but i don't have the funds with my newest rebuilt along with learning to tune the proEFI. :*(
going for the proEFI huh? I wish i could take the hit and jump ship but i don't have the funds with my newest rebuilt along with learning to tune the proEFI. :*(
Thread
Thread Starter
Forum
Replies
Last Post




