Dentless Repair applicable for the Rear Bumper?
05-23-2006, 05:38 PM
#1
Registered User
Thread Starter
Join Date: May 2006
Location: Southern Maryland
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Dentless Repair applicable for the Rear Bumper?
I have a small indentation on my rear bumper of my 350Z, top right corner above the tag. Can the Dentless Repair method that is done on sheet metal be performed on the plastic rear bumper? Or will it flex back to it original shape over time if I just leave it alone? Has anyone tried it?
Man, that bumper is thin..........
Man, that bumper is thin..........
05-23-2006, 08:56 PM
#2
Guest
Posts: n/a
not really the urethane takes a different method instead of the pop a dent methid.
the best way to do it is heat up the bumper a little and try to smooth it back out.
i had a small crease in mine and i used a hair dryer and made it a little better.
the only problem with this method is you can stress crack the paint if you use too much force. and second after time mine went back to the original crease.
the best way to do it is heat up the bumper a little and try to smooth it back out.
i had a small crease in mine and i used a hair dryer and made it a little better.
the only problem with this method is you can stress crack the paint if you use too much force. and second after time mine went back to the original crease.
Thread
Thread Starter
Forum
Replies
Last Post
Lt_Ballzacki
Brakes & Suspension
39
08-06-2021 06:19 AM
