Anyone Order from clearCorners.com??
I C they make side markers for are cars, here is the link
http://www.clearcorners.com/products...3/F_srflx_LED/
Later
Aceman
http://www.clearcorners.com/products...3/F_srflx_LED/
Later
Aceman
I was thinking about it, but for $200 a pair and you have to send him your reflectors to work on for a few weeks before they're ready... time and cost just didn't seem to warrant it.
I do really like the full strip LED idea though... *hint*hint* in case anyone here wants to try putting some together.
Either way, I've got Skidazzle's three dot LED clears installed and for right now, those are fine.
I do really like the full strip LED idea though... *hint*hint* in case anyone here wants to try putting some together.
Either way, I've got Skidazzle's three dot LED clears installed and for right now, those are fine.
I have my stock pair of ambers here, if someone wants them I could most likely create a set of sidemarkers just like them...
you order the LEDs, have them shipped to me, and Ill make em. doesnt look that difficult at all...
not sure how much Id charge, if anyone actually wants them Ill figure it out, but I know it would be ATLEAST half what their charging....
you order the LEDs, have them shipped to me, and Ill make em. doesnt look that difficult at all...
not sure how much Id charge, if anyone actually wants them Ill figure it out, but I know it would be ATLEAST half what their charging....
oh sure, NOW you tell me you can do the same thing... after I bought my 3-dots from skidazzle. not that I'm unhappy with the 3-dots it's just that I have always preferred to have the entire sidemarker light up.
my question to you is, could you make them clear? lenses and all.
my question to you is, could you make them clear? lenses and all.
Yeah, I had them make clear rear sidemarkers for my Z32. After emailing without response about 3 times, I finally got them back after two plus weeks. They look pretty good, but he hadn't countersunk the screw holes like they needed. Little details like that matter, if you're paying $100 to someone for an hour or two's work, as far as I'm concerned. Plus the poor response to my emails.... It's up to you. Like I said, decent product, less than decent customer service. Although he is a very enthusiastic individual who is very interested in cars and lighting products, he's probably screwing around with them too much to get much work done in a timely manner. But, there aren't many people doing this stuff professionally, and it's probably a little trickier than you think, so you decide. Good luck.
Thread
Thread Starter
Forum
Replies
Last Post





