diy powdercoaters, what is your setup?
#1
hatersgonnahate
Thread Starter
iTrader: (162)
diy powdercoaters, what is your setup?
Im looking into a basic setup to do some powder coating. figured for the price to have someone powdercoat my stuff i could just get the equipment and do it myself. plus, ill offer my service to locals and make my money back in no time.
where did you order your equipment?
how hard is it to do?
where do you get your supplies?
anyone try to match the turbonetics piping finish?
what size oven do you use? Id need one to run off 115v.
not sure if there is a right forum for this topic, it kinda falls into detialing/body work and painting.
where did you order your equipment?
how hard is it to do?
where do you get your supplies?
anyone try to match the turbonetics piping finish?
what size oven do you use? Id need one to run off 115v.
not sure if there is a right forum for this topic, it kinda falls into detialing/body work and painting.
#2
hatersgonnahate
Thread Starter
iTrader: (162)
Ok, ill post mine.
Hot Coat System from eastwoodco.com
Haier RTC1700 Toaster oven, largest in the market
8 gallon air compressor
Several colors of Powder
Its a amateur setup for sure, but it does what i need it to.
Hot Coat System from eastwoodco.com
Haier RTC1700 Toaster oven, largest in the market
8 gallon air compressor
Several colors of Powder
Its a amateur setup for sure, but it does what i need it to.
Thread
Thread Starter
Forum
Replies
Last Post
350Z_Al
Exterior & Interior
133
10-29-2020 07:44 PM