Parts/clips holding rear body kit together
Thread Starter
Registered User
Joined: Jan 2008
Posts: 4
Likes: 0
From: walnut
Parts/clips holding rear body kit together
Recently, AAA tried towing my car up the ramp but because it was too low the rear panel came off a bit when it hit the ramp. This is rear body attached to the side fender that has a noticeable gap now. I notice there are some clips attached between the 2 parts, is it an easy fix by just screwing something in. Or do I need a special took to get that rear panel alligned?
Thread Starter
Registered User
Joined: Jan 2008
Posts: 4
Likes: 0
From: walnut
Anybody?
Looks like this
The area right below the rear light, has a noticeable gap. But it looks like its held on by clips, I couldnt get a great view of it cuz its underneath. Is there a way to secure it? It's stock by the way.
Looks like this
The area right below the rear light, has a noticeable gap. But it looks like its held on by clips, I couldnt get a great view of it cuz its underneath. Is there a way to secure it? It's stock by the way.
Last edited by Danny234; Jan 30, 2008 at 11:11 AM.
Registered User
Joined: Oct 2004
Posts: 1,055
Likes: 0
From: NJ
Thread
Thread Starter
Forum
Replies
Last Post
350Z Project X
Suspension
9
Oct 10, 2015 09:23 AM