saberphx

iTrader: (5)

Anyone know where I can find a step by step for this? I couldn't find anything with the search feature.

Need to remove my rear fenders to make wider fenders out of fiberglass. I imagine you have to cut the inner seam in the wheel well.
Or is it too much of a b*tch to do and recommend making over-flares. Is the do-luck rear fender a piece which goes over the fender or replaces it?

Any help or tips is much appreciated!!

Carbon-Z

Umm you can't remove the rear fenders unless you plan to cut the welds all along the bottom, trunk and roof and door area.

It's welded all around.

350ZTheStandard

iTrader: (4)

The kits usually go on over the existing body panels, or you could do brain salad surgery.

saberphx

iTrader: (5)

Thanks for the replies, I thought removing it would be a few bolts and the bottom inner seam weld but I guess not. I thought it was possible because the do-luck rear fenders look seam-less and as if they replace the rears. Guess its just an add on and thats what I will be doing.

Thanks again for the replies.