ZTEALTH

is there anybody out there making aftermarket door handles? don't hate me, but it's the only thing on my Z that i wish was flushed, maybe like the G35's.

moforeynolds

iTrader: (5)

I got this one from Frigidaire:







I don't think a bolt-on flush handle would be possible because of the design and placement of the latch. you could always shave them off and use door-poppers if you like...I don't like the look nor do I recommend that mod, but it depends how badly you dislike those door handles.

ncparamedic

iTrader: (49)

how about just shaving your handles..

Spork

iTrader: (6)

+1

Denum

fail.

Spork

iTrader: (6)

You fail for not sensing the humor and not owning a Z yet.

Denum

kz u so funnies

SuperBlack350z

iTrader: (59)

Denum

stick it in silverstone a little harder next time k.

Spork

iTrader: (6)

Yo, I'm a dude... If that's how you swing... Don't point a limp wrist at me.

azula

iTrader: (12)

owned again

ZTEALTH

i'm actually looking for something smoother, less mechanical looking. not really flushed. shaved handles and poppers are for 51' mercurys, not sports cars! would there be a large enough demand for me to CAD some up and get some made over seas?

ZTEALTH

.

Agentman03

Can't remember what the G35's look like ? do they look like a fit ?

T_K

iTrader: (5)

FD RX7 door handles would be nice, or NSX too. Anything along the lines of that I'd buy.

TK

Spork

iTrader: (6)

The new Corvette's handles are pretty cool IMO.

They are stationary and have the rubber button like our trunk release above our rear license plate.

03redlineZ

iTrader: (59)

The FD's and NSX's are on the door sill we dont have the sill on our Z's... It is a good call though because it give the appearance there is no door handle but its up where our B-Pillar is...

I had subscribed a while back to someone who started producing a different door handle and was going to create a more flush (not entirely flush handle since that would be almost impossible).

The corvette handle idea as stated by silverstone above is a good idea but would definately need some serious R+D to make that work... Would look great though once it was finished...


I think the issue is knowone has the time or money to do all the research and development and then mass produce a handle....Keeping fingers crossed I am wrong...

kenjisan

yup +1 for the fd door handles...why doesn't anyone get their handles painted to match the rest of the car.

JETPILOT

iTrader: (51)

tranceformer95

iTrader: (20)

I've seen it done a few times. Depending on the color it looks a bit cheesy, but that's just my opinion.