shiftknob installation...
#1
Registered User
Thread Starter
Join Date: Jun 2008
Location: Denver
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
shiftknob installation...
After about an hour tryin to twist the damn shiftknob and I finally gave up...It's an 06 Manual Trans. I followed the steps of the installation guide that came with the shiftknob, but I still can't get the **** off..It's like superglued on to the shifter or something. Can anybody help me to get this thing off in easier way? Or I might just take it to nissan and have them do it. Kinda afraid to damage my tranny...
#2
New Member
iTrader: (27)
Use channel locks to hold the bottom of the post, then use another set with a rag or something to protect it and twist it off. I got mine off by hand so it shouldnt be on there that thight. check page 2- https://my350z.com/forum/body-interi...ft-****-2.html
#5
Registered User
iTrader: (12)
Join Date: Dec 2004
Location: McAllen / San Antonio TX.
Posts: 2,087
Likes: 0
Received 0 Likes
on
0 Posts
let your car sit in the sun for a few hrs before you try it again....then i had the help of another person to hold the shifter pole with channel locks wrapped in rubber bands and i said **** you stock shift **** and tore the crap out of it and it popped right off.
#7
Registered User
iTrader: (3)
Join Date: Oct 2007
Location: Queens, NY
Posts: 581
Likes: 0
Received 0 Likes
on
0 Posts
Vice grips on the shaft, pipe wrench on the ****(with a cloth to protect the ****). I ripped a few pieces of skin off my hand trying to twist it off without the tools. Nissan started putting some form of Locktite on later model Z's.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post