cant wait to do it too!!! just waiting for my greddy ti-c to get here already!!!!!

looks good boss =D

 

Ok, that does look cool. Change my vote now!

Also, lower the rear end!

 

looks good dude what exhaust is that?

 

I know what you mean about catching airflow, the middle is starting to bend back a little because of the wind it catches. I might have to screw it in. besides I have the single greddy and bringing it down in the future would look dumb with a single exhaust.
[/IMG]

 

Thanks everyone! Car will be lowered in a bit.


Thanks man. it's the Apexi N1 Evolution.

 

The z is going to look sick once you lower it

 

Do you like your greddy single? Greddy ti-c? right?

 

I debated on doing this myself. I think I'll do as well. Imitation is the greatest form of flattery. Thanks Spork.

 

I hope so.

Glad to be of help.

 

I don't have to worry about the paint cracking anymore do I?

It's perfect right now, but will it crack when the weather gets really cold? Or will I be fine.

 

I haven't heard of anyone having that issue and this mod has been around a while now. Mine is still fine!

 

Alright sweet! Thanks man.

 

Spork your tuck looks perfect!!! How did you do it?? What exact bolts did you use??

 

Thanks!

Pretty simple. I had the jack holding the right side against the bumper support just so I didn't have to hold the whole thing up.

Drilled 4 - 7/64" holes through the bumper and through the bumper support in one shot.

Screwed two of the bolts in, then removed the jack and drilled the 7/64" holes on the side where the jack was.

Then, I just finished screwing in the rest of the bolts and tightened them all down.




These are the screws/bolts I used. Ignore the red heads, I ran out and grabbed one quick and it happened to be red.

 

hehe lol! it does look like a skid mark.

...But the bumper looks great like that.

 

How deep into the bumper did you make the holes? From the bottom.. Im asking because yours looks a lot better than I have ever seen.. You cant tell its tucked... Looks OEM..

 

Like how far from the edge did I screw in?

It's hard to say... I'll go out once I'm done eating and I'll get you some measurements. I just aimed to get as close to the edge of the bumper support as I could.

 

Yep, I want exact.. I want to do it exactly the way you did..

 

Middle of screw to bottom edge of bumper flap.


Side of exhaust hole to first screw.


Distance from first screw to right-middle screw. Same measurements from the other side.

 

Quick paint work.